I've never used the 5v rail on its own, but I've used the 12v rail for various things. They do make great high amperage supplies. You have to short the green wire in the main 24 pin connector with one of the many black ground wires and then it'll turn on.
-- Wyatt Zacharias (mobile) On 15 Feb 2016 3:59 p.m., "Hartmut W Sager" hwsager@marityme.net wrote:
The -5V and -12V are probably fine with no load, but the +12V line should have at least the minimum required load (whatever that might be). Just use a suitable power resistor (power resistor means it won't fry into a molten lump) on the +12V line. In the absence of info on the PS label, I'd go for loading the +12V line with about 10% of its maximum power/amps. Use V = IR and P = IV to do the algebra to get the right resistance (ohms).
Also, along the lines of Adam's reply, you might have to signal back to the PS (by closing a circuit?) that "this motherboard likes you" - otherwise the PS might cut out.
Hartmut W Sager - Tel +1-204-339-8331, +1-204-515-1701, +1-204-515-1700, +1-810-471-4600, +1-909-361-6005
On 15 February 2016 at 15:39, Trevor Cordes trevor@tecnopolis.ca wrote:
Is it possible to use a standard AT (old style) computer power supply just for its +5v out? I have a project and I just need 5v with a beefy amount of amps, and I have lots of AT PS's around that would fit the bill, but I'm wondering if running a computer PS just for its 5v line might damage it somehow? There would be no load on the 12v (and other) lines. Anything I should worry about?
Thanks! _______________________________________________ Roundtable mailing list Roundtable@muug.mb.ca http://www.muug.mb.ca/mailman/listinfo/roundtable
Roundtable mailing list Roundtable@muug.mb.ca http://www.muug.mb.ca/mailman/listinfo/roundtable