Digikey should have a connector that meets your needs, but you'll probably have to take some measurements and then check the data sheet of the one you plan to buy to make sure it'll match your holes properly. Make sure to go to the Canadian site: digikey.ca. Shipping is flat rate $8, no other duty of fees.
-- Wyatt Zacharias (mobile) On 19 Feb 2016 8:35 p.m., "Robert Dyck" rbdyck2@shaw.ca wrote:
I have a customer who needs some parts fixed. She bought a pair of used tanning beds. They don't work. Fixing that isn't what I do, but this customer actually pays. One of the employees brought a circuit board with an RJ12 jack. The jack was yanked out. I tried to straighten, but couldn't. Tried to desolder to losen it, but then the jack came apart. I need a new jack.
This is a phone jack. RJ11, RJ12, and RJ14 all use the same plastic. RJ11 = 6P2C (6 pole, 2 contacts) RJ12 = 6P6C RJ14 = 6P4C
The cables all have 4 wire, but the jack has 6 solder points. It has 2 plastic posts, and the wires go through holes in the circuit board.
I first looked at Active Electronics website, but the only ones they have use punchdown connections. Where would I get one that solders?
Rob Dyck
Roundtable mailing list Roundtable@muug.mb.ca http://www.muug.mb.ca/mailman/listinfo/roundtable